Flashing error with Drag and Drop due to Windows update

[polat-ahmet]

While flashing the max32666fthr board with Drag and Drop using max32625 debugger, it often fails(nearly 70% fail, %30 success). It's ok when I try with small size(~40kb) binary, but I'm having trouble with bigger size(~500kb) binary.

It was working properly before. I observed the problem using Windows updates KB5026361, KB5025221. When I uninstall these updates and tried it on KB5023696, I did not encounter any problems, successfully flash.

The fail message:

error: File sent out of order by PC. Target might not be programmed correctly.
type: transient

This is the DETAILS.TXT of the DAPLink Firmware I used.

@mathias-arm It is a blocker issue for our release we will appreciate if you take a look and provide your feedback asap.

[mathias-arm]

This sounds like a duplicate of #1025. Let's move the discussion there.