A physical bread board simulator.
physical & algorythmical code: Ali Mozdian fard graphical code & designer: Pooya Shams
WELCOME TO DIGI-BOARD GUIDE
1- voltage (number): This tool can change the voltage of bread board
2- planting tools:
2.1- LED: This tool can plant a LED on your bread board
2.2- wire: This tool can connect a wire on your bread board
3- check tools:
3.1- check voltage: This tool says how much is the voltage in your bread board.(measured in volt)
3.2- check LED: This tool says about all of LED.
(anodes pos, cathodes pos, color, required voltage)
3.3- check wire: This tool says about anodes' & cathods' pos of all of wire.
3.4- check (point): This tool says about the points content.
4- system tools:
4.1- screenshot: This tool can take a picture.
4.2- save: This tool can save your new board.
4.3- open: This tool can open your saved board.
4.4- rename: This tool can change name of your new board
5- deleting tools:
5.1- z: This tool's mean 'Ctrl+Z'.
5.2- del: This tool can delete an item. (like LED or wire)
5.3- restart: This tool can restart your board & delete all of your LEDs and wires
6- refresh: This tool refreshs your board.
7- clear: This tool can clear the terminal
8- guide: this tool can declare to you, the tools
9- quit: This tool closes your board.
10- cod: This tool is just for debugging the programme by programmers of digi-board (Ali & Pooya)