Skip to content

Releases: CYBUTEK/KerbalEngineer

Kerbal Engineer Redux v1.0.13.1

16 Dec 22:48
Compare
Choose a tag to compare
Fixed: Issue with manoeuvre node readouts and low tier tracking station.

Kerbal Engineer Redux v1.0.13.0

16 Dec 01:35
Compare
Choose a tag to compare
Updated for KSP version 0.90

Added: New readouts to the vessel category:
    - Heading Rate
    - Pitch Rate
    - Roll Rate

Changed: Simulation to look for fuel lines that use CModuleFuelLine module.
Fixed: Editor Overlay now loads the saved visibility value properly.
Fixed: Altitude (Terrain) will no longer give a reading below sea level.
Fixed: Suicide burn now uses radar altitude that clamps to sea level.

Kerbal Engineer Redux v1.0.12.0

01 Dec 03:40
Compare
Choose a tag to compare

Added: Setting in Build Engineer to enable/disable vectored thrust calculations.
Added: Thrust torque field in Build Engineer (courtesy of mic_e).
Added: New readouts to the vessel category:
- Thrust Offset Angle (courtesy of mic_e)
- Thrust Torque (courtesy of mic_e)
- Part Count: stage/total
- Heading
- Pitch
- Roll

Added: New readouts to the surface category:
- Situation

Added: New readouts to the miscellaneous category:
- Vectored Thrust Toggle

Fixed: The category selection within the section editors now do not always reset back to 'Orbital'.
Fixed: Issue where the vessel simulation can sometimes permanently freeze.
Fixed: Issue where the vessel simulation would not show updates when the delay was set lower than the frame rate.