-
Notifications
You must be signed in to change notification settings - Fork 26
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Marlin 2.1.1 Error #241
Comments
Just wanted to add - Formerly, i had Arc Welder 1.0 and now I have the RC4 |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I have enabled #define ARC_Support in Marlin 2.1.1. However, the Arc-Welder plugin indicates the following error in OctoPrint.
Your firmware may have issues running gcode produced by Arc Welder. You may need to alter firmware settings or upgrade to a newer version.
Last Check On:08/30/22 10:32:36
Name:Marlin
Version:2.1.1
Supported:Yes
Arcs Supported:Yes
3D-Arcs Supported:Yes
Arcs Enabled:Yes
Newer Version:This firmware is newer than the most recent version in the Firmware Library. Some info may be outdated.
Errors:
Your firmware requires the 'G90/G91 Influences Extruder' setting to be ENABLED. Edit the Ocotprint feature setting 'G90/G91 overrides relative extruder mode', set the value to ENABLED, and run the firmware check again.
This never occurred with 2.0.9.3. I had same enablements.
The text was updated successfully, but these errors were encountered: