XMC1100 Boot Kit
This pages summarizes information about the XMC1100 Boot Kit evaluation board and its implementation for the Arduino IDE. The XMC1100 Boot Kit board consists of a XMC1100 microcontroller with a debugger implemented by a XMC4200 microcontroller. The Infineon homepage of the board can be found here.
The pin layout of the XMC1100 Boot Kit for the Arduino IDE is as follows (the original file can be found here).
Please note that Arduino pin number 16 & 22 (SCL & A5) and Arduino pin number 15 & 21 (SDA & A4) are not connected with each other nor share the same pins/resources. This is different from the original Arduino UNO Rev3 implementation.
- XMC1100 Microcontroller (ARM® Cortex™-M0 based) in TSSOP-38 with 64 KB Flash and full peripheral set of XMC1100 series
- Detachable Segger J-Link (implemented with XMC4200)
- Board shape & power supply for Arduino shields: Shield List.
- Infineon shields - Hardware compatible with Arduino
In case you want to change the design or reuse it for your own projects, please find the XMC1100 Boot Kit board design for EAGLE under the following link:
XMC1100 Boot Kit PCB Design Data
A PDF summarizing the features and layout of the XMC1100 Boot Kit board is stored on the Infineon homepage here. The datasheet for the XMC1100 can be found here XMC1100 Datasheet while the respective reference manual is located here XMC1100 Reference Manual.