Aqara smoke detector JY-GZ-03AQ

[brjhaverkamp]

Hi all,

I have a couple of Aqara zigbee smoke detectors (JY-GZ-03AQ). I have connected them in z2m and now want to make sure they all sound the alarm when one detects smoke

I got the "sound-the-alarm" part working via linkage_alarm_state. If that variable is true, I can send a buzzer="alarm" to all other detectors.

However, I also want to "mute-them-all" when I press the button on one of them. (I don't want to run through the whole house muting all detectors individually). This part I haven't been able to get working yet. What exposed variable/property indicates that a button has been pressed on these devices?
I have been trying to use buzzer_manual_mute. But that doesn't seem to change when the buzzer is muted manually (via pressing the button) Actually I am not even sure if "manually" indicates "via an MQTT message as opposite to actual smoke detected" or via a "manual button press as opposite to an automated trigger(mqtt or smoke)"

I am trying to write a function in node red to connect everything. But sofar only the sounding of the alarms works. Any hint on how to get them all muted again is appreciated.

Kind regards,

Bert

Regards,

Bert

[Jens-Wymeersch]

@brjhaverkamp Hi Bert,
Just wondering if you were able to get this sorted out ? And do the JY-GZ-03AQ work well with Z2M ?

[Jan1503]

I just bought a pair of these devices to test and eventually replace my nearly 10-years old Ei 650 detectors.
Since they are 'officially' usable in EU now I was hoping to find a smart replacement which tells me some stats and most importantly where the smoke was detected first. I have around 30 Ei devices installed which should be replaced by 06/25.
Being able to mute the new aqaras via mqtt is crucial but also have to find out how reliable these devices are...