Replies: 2 comments 3 replies
-
While OpenFAST doesn't have an option to specify The "Ideal_Beam" tests in the OpenFAST r-test (https://github.com/OpenFAST/r-test/tree/main/glue-codes/openfast) may be good examples as the parameters are set so that OpenFAST models only a single uniform beam. Best regards, |
Beta Was this translation helpful? Give feedback.
-
Thank you @jjonkman for your reply and sorry for my late response. I think i did not clarify very well the goal of simulating OpenFAST without blades. In fact, i am interested in studying the motion of the tower during blade installation process. However, the test you have suggested does not enable the tower degrees of freedom. Only the platform DoFs are enabled. Best regards, Riad |
Beta Was this translation helpful? Give feedback.
-
Hello everyone,
I am interested in simulating OpenFAST without blades. When i set NumBl = 0, it gives an error and it displays that NumBl should be positive.
Is there any trick to do it in order to run a simulation without any blades ?
Thank you for your help.
Best Regards,
Riad
Beta Was this translation helpful? Give feedback.
All reactions