Why response body is not showing for failures #445
-
|
@TwiN Is it possible to show the response body for failures? Its not showing right now |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
|
@TwiN Is it possible to show response body for failures? |
Beta Was this translation helpful? Give feedback.
-
|
You can use the Here's an example: |
Beta Was this translation helpful? Give feedback.
-
|
@TwiN I think there are some scenarios where the Body doesn't match the defined JSON structure. Below is an example.
OP raised a good point, it would be useful to check the full body in case of failure. |
Beta Was this translation helpful? Give feedback.
You can use the
[BODY]placeholder to check for a specific value in the body, and if the specific value is not found, the actual value will be shown (depending on the length of the body, it may be truncated)Here's an example: