These are official materials I have planned to use, it will be the final construction list. Prices here are expressed in metric measurements and euros (still simple to translate for US Folks too)
- Quimat 3D Printer Controller Kit for Arduino Mega 2560 Uno R3 Starter Kits +RAMPS 1.4 + 5pcs A4988 Stepper Motor Driver + LCD 12864 for Arduino Reprap. This is a common RAMPS controller easily available everywhere, it's not the cheapest one but it's well known and respected for its reliability. Available from fareast (for less) and west retailers in various formats
- 3X Mechanical Endstop Module. These are quite cheap and I'll use them until I'll finish v1.0, on v2.0 I'll use home made optical endstops. BTW getting these parts already assembled it's better than build them from scratch, at least to complete the project
- #2 Square steel tube from local hardware store: 30x30x200(mm) ~17.00€ [each]
- #10 Aluminum GT2 Timing Belt Pulley 20 Teeth Bore 5mm Width 6mm (two spares) amazon
- Reinforced steel rod ø8x200mm - 5.80 €
- #1 5 Meters GT2 2mm pitch 6mm wide Timing Belt amazon
- #10 LM8UU Linear Ball Bearing Bush Bushing for 8mm Rod amazon
- #10 Machifit 10pcs 6x17x6mm 606zz Steel Sealed Shielded Deep Groove Ball Bearings banggood
- #1 pack (4 cables) Bipolar Stepper Motor Cables for Reprap 3D Printers CNC Machines 1m Pack of 4 amazon
- #2 Aluminium Bar rod from local hardware store: 8x1000(mm) ~4.00€ [each]
- #1 Aluminium steel bar 40x15x1000(mm) ~2-3€(?)
- #1 U-shaped aluminium bar 15x15x1000(mm) ~3€
- #1 U-shaped steel mount bar 80x80x80(mm) ~3€
- #1 Flat aluminium milled plate (used for baseboards or steps) from local hardware store: 25x1000(mm) ~2.50€
- #5 Flat inox steel for joints [90x90mm] from scrap materials, adapt and cut it to the right shape. for free