cariboulite
#114
Replies: 2 comments
-
Found the reason for install errors dtparam=i2c_vc=on in DragonOS, following advice posted by one individual to use : ./boot/firmware/install.sh., after changing the installation to original /boot/config.txt to enable, it installed without error. Still no device of caribou shows up in programs to connect to in DragonOS. |
Beta Was this translation helpful? Give feedback.
0 replies
-
I see this has been closed as resolved even when no help has been given, thanks to whoever did this. Still no solution has been posted. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I have tried to get cariboulite to work, tried under raspberrypi latest version, even 32 bit version. Installation seemed to go ok, after installation I tried gqrx and cubicsdr, both showed 2 types of caribou in devices, but no signal present when program enabled. Tried DragonOS, but ran into many difficulties in installing cariboulite, and after many hours updating/upgrading cannot get it installed, 2 errors occur, dtparam=i2c_vc=on,(I made sure this was in the config.txt file in "boot", unable to locate raspberrypi-kernel-headers, cannot create directory "build". So have given up on DragonOS. Tried all suggestions posted about this, no sucess. Any ideas how to install cariboulite and get it to work? Running on raspberrypi 4 B 8 gig memory.
Beta Was this translation helpful? Give feedback.
All reactions