-
Notifications
You must be signed in to change notification settings - Fork 819
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Meshes alignment failure #1466
Comments
if one of the meshes in the pair has a lower quality (eg: noisy or incomplete or slightly distorted), pressing Process fails for me. If this is not the case, it works from my experience. So the question is perhaps about how to ensure both meshes have an adequate quality standard? So far, changing the parameters of this tool did not help much without upgrading anything else. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Similar to what has been reported outside this discussion forum, also experienced the same issue; “ I have two meshes that I'm trying to align in MeshLab but can't for some reason. I've used "point based gluing" and chose (in may case 10 pairs). The meshes align almost, but I cannot get it to process.
The failure is: "Failure. No successful arc among candidate Alignment arcs. Nothing Done."
I will try to find the source code for this and keep trying to solve it. Otherwise , stuck here atm. Any suggestions?
The text was updated successfully, but these errors were encountered: