Unable Run the Simulation

[TsingYi11]

<<<+- config init -+>>>
reading material configuration
Segmentation fault,
After I rebuilt the EBSD file in DREAM3D software, configured geom, material, and load, and ran the simulation, an error message appeared. However, if I cut a part of the EBSD and repeated the same steps, I found that it could run, but the result differed from what I wanted, and the strain value was minimal. I hope to get your help.

[MarDiehl]

probably you run out of memory.

[TsingYi11]

Thanks

[shiningpy]

Hi, there, do you guys figure this issue out? I encounter the same problem with yours. I tried almost everything to reconfig the material.yaml and goem.vti from the dream3D file. However, the propramme keep reporting:
<<<+- config init -+>>>
reading material configuration
Segmentation fault (core dumped)
Could you please help me out of this?

[MarDiehl]

without further details it's not possible to give an answer. pls have a look at https://damask-multiphysics.org/support/helpdesk

[shiningpy]

Thank you very much for your response.

[shiningpy]

without further details it's not possible to give an answer. pls have a look at https://damask-multiphysics.org/support/helpdesk
I have one more question. Can DAMASK be used to simulate the deformation behavior of NiTi alloys? NiTi alloys involve a stress-induced martensitic transformation, which causes a phase change from cubic B2 to monoclinic B19'.