Segmentation fault when reading large material configuration file

[123fgh123]

I founded that when the material configuration file is quite large, the simulation can’t run and lead to an error “Segmentation fault”：

"
<<<+- config init -+>>>

reading material configuration

===================================================================================
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= PID 3653756 RUNNING AT node932
= EXIT CODE: 139
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES

YOUR APPLICATION TERMINATED WITH THE EXIT STRING: Segmentation fault (signal 11)
This typically refers to a problem with your application.
Please see the FAQ page for debugging suggestions
"

I have attached my simulation files for further check.

Thank you.

large_mat_file.zip

[ToxFox88]

Try to add "ulimit -s unlimited" string before DAMASK running or include it to your *.sh file if you use it.

[123fgh123]

I have tried your method and it works well. Thank you very much!