Under utilization of 2x 2TB NVME? #534
-
It seems after 8 hours or so that my drives aren't getting anywhere near the recommended 6-7 concurrent plots per 2TB NVME and I think I'm running close to recommended settings... Any tips on the below? I have..
|
Beta Was this translation helpful? Give feedback.
Replies: 2 comments
-
I am not an expert, but I had the same problem. I increased the stagger phase limit. Right now with it set at 1 you can only have 1 job of that type per phase. etc 1 job in phase 1, 1 job in phase 2. I changed mine to 2 and now I run 2 in each phase 1, 2 ,3. |
Beta Was this translation helpful? Give feedback.
-
tmpdir_stagger_phase_limit: 1 Now you can only have 1 active job that is below phase 2:1 per drive. |
Beta Was this translation helpful? Give feedback.
I am not an expert, but I had the same problem. I increased the stagger phase limit. Right now with it set at 1 you can only have 1 job of that type per phase. etc 1 job in phase 1, 1 job in phase 2. I changed mine to 2 and now I run 2 in each phase 1, 2 ,3.