Replies: 5 comments 4 replies
-
|
When you enable relay support, a config sections is added to the devices screen. It lets you set the GPIO. |
Beta Was this translation helpful? Give feedback.
-
|
I got this far with my d1 mini, however all the gpio boxes are red with exclamation and I can't edit them... it is just the d1 with no other mb, looking g to just operate a 4 relay board @131.. thx for putting this all together btw |
Beta Was this translation helpful? Give feedback.
-
|
I am not seeing such an issue: |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
Edit: wow, ok these cells were uneditable in chrome on my android phone. In chrome on windows, they all pre loaded with gpio "4294967292" in every field (but still red). From windows chrome I could edit and save.... |
Beta Was this translation helpful? Give feedback.
-
|
Yes they start as a -1 which is not valid. You need to set them to a value that is valid. |
Beta Was this translation helpful? Give feedback.
-
|
awesome, thanks for your patience. i have this pretty close to working but had two more q's if you are able... i have only ddp input and the 2nd relay output enabled. in xlights, if i apply the 4 relay models to the only open pixel port (1) in the visualizer, the test chase works fine cycling the relay states until either xlights auto uploads or i manual upload to espixelstick. then it forces espixelstick input 1 to be ws2811 and output 1 to be ws2811,and then the relays get bumped out and no longer respond... do i need to uncheck the upload features for the controller or is this something i'm setting incorrectly in the relay model? (i only see protocol options like ws2811 or dmx for the model, and they both cause this enabling output1 issue....
|
Beta Was this translation helpful? Give feedback.
-
|
Sorry but I am a vixen guy. You will need to go to the xLights forum to see how to deal with this. |
Beta Was this translation helpful? Give feedback.
-
|
no worries, thanks for the help. thought it might be something how the espixelstick handles the incoming uploads. |
Beta Was this translation helpful? Give feedback.
-
I have a D1 pro mini (Esp8266) with 16M. I have espixelstick v 4,0 installed. I can connect to the web, and on the home page see that I am connected to the d1 mini pro. I do not see anywhere to configure pins for relays or pwm. I checked advance mode under the admin tab, but that doesn't seem to help. What am I missing?
Beta Was this translation helpful? Give feedback.
All reactions