Error Using AnnularMesh

[zsren]

Hi,

I am having receiving error message while using annular mesh. Could you please help on this? Thanks so much!

ZR

*** ERROR ***
Each subdomain must contain at least one Kernel.
The following block(s) lack an active kernel: 1 

Stack frames: 11
0: 0   libmesh_opt.0.dylib                 0x000000010ae223a3 libMesh::print_trace(std::__1::basic_ostream<char, std::__1::char_traits<char> >&) + 1091
1: 1   libmoose-opt.0.dylib                0x000000010a2b2a07 moose::internal::mooseErrorRaw(std::__1::basic_string<char, std::__1::char_traits<char>, std::__1::allocator<char> >, std::__1::basic_string<char, std::__1::char_traits<char>, std::__1::allocator<char> >) + 823
2: 2   libmoose-opt.0.dylib                0x00000001094535b1 void mooseError<std::__1::basic_string<char, std::__1::char_traits<char>, std::__1::allocator<char> > >(std::__1::basic_string<char, std::__1::char_traits<char>, std::__1::allocator<char> >&&) + 257
3: 3   libmoose-opt.0.dylib                0x0000000109e29f47 NonlinearSystemBase::checkKernelCoverage(std::__1::set<unsigned short, std::__1::less<unsigned short>, std::__1::allocator<unsigned short> > const&) const + 4471
4: 4   libmoose-opt.0.dylib                0x0000000109942834 FEProblemBase::checkProblemIntegrity() + 1572
5: 5   libmoose-opt.0.dylib                0x0000000109cc339f ActionWarehouse::executeActionsWithAction(std::__1::basic_string<char, std::__1::char_traits<char>, std::__1::allocator<char> > const&) + 1359
6: 6   libmoose-opt.0.dylib                0x0000000109cf2ed8 ActionWarehouse::executeAllActions() + 280
7: 7   libmoose-opt.0.dylib                0x000000010a2839f2 MooseApp::runInputFile() + 98
8: 8   libmoose-opt.0.dylib                0x000000010a27ef40 MooseApp::run() + 960
9: 9   in718-opt                           0x00000001083ffbe4 main + 132
10: 10  libdyld.dylib                       0x00007fff6bdb7cc9 start + 1
application called MPI_Abort(MPI_COMM_WORLD, 1) - process 0
[unset]: write_line error; fd=-1 buf=:cmd=abort exitcode=1
:
system msg for write_line failure : Bad file descriptor

[GiudGiud]

Hello

The mesh contains a block with no kernels.
Very likely, the variables or the kernels are block restricted, and your mesh contains several blocks. Some of these blocks are not covered by the block restriction you are using

Guillaume

[GiudGiud]

you could paste your input here if you dont find the block restriction issue

[zsren]

Hi Guillaume，

Thanks for your prompt reply and helpful suggestions! I found the issue and it works now.

ZR