-
|
when i coupled modflow with cwatm, the result only shows the MODFLOW outputs.And i can't find the error.The settings file and the cmd screen uploaded below.The template i used is "CWatM-Earth-30min",and the part of modflow came from "cwatmmodflow6_github.zip" |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 4 replies
-
|
Hi Wang, Thanks for reaching out. Modflow can be a bit tricky sometimes. Please provide the 'TRANSIENT.lst' file from this folder: PathGroundwaterModflowOutput = F:\cwatm_output\north_east4\dbmodflow |
Beta Was this translation helpful? Give feedback.
-
|
I'm sorry, but the output floder doesn't have the 'TRANSIENT.lst' file,it just output 16 files.And there is two probem i have met. In 'preprocessing_forModFlow' section,i have changed "gdf['DN']" into gdf['geometry'] in "create_raster.py", and remove "libmf6.dll" and "mf6.exe" into "D:\Documents\GitHub\CWatM\cwatm"floder by the error. Could these changes make wrong? |
Beta Was this translation helpful? Give feedback.
-
|
Please check that your 'xmipy' version is set to 1.0.0. The modflow coupling necessitates this version. |
Beta Was this translation helpful? Give feedback.
-
|
Yes, that's the problem! Thanks again for you apply. |
Beta Was this translation helpful? Give feedback.
-
|
haiqing，您好，我能请教您一些问题吗？ |
Beta Was this translation helpful? Give feedback.
-
|
可以，你说 |
Beta Was this translation helpful? Give feedback.
-
您好，王师兄。我是河南大学地理与环境学院2023级的一名研究生。 |
Beta Was this translation helpful? Give feedback.
Please check that your 'xmipy' version is set to 1.0.0. The modflow coupling necessitates this version.