A simple daemon used to play audio on another computer's output over the network.
- 🚀 Simple, Rust-based daemon.
- 💻 Compatible with Linux (PulseAudio/ALSA) and macOS (CoreAudio). Windows untested.
- 🛜 Low latency (real world testing shows 500-800ms end-to-end).
- 🔕 Optimizations to reduce bandwidth when no audio is playing.
- 🔉 Allows any sample rate & buffer size supported by both audio devices.
- 💻 Integrates live terminal-based stats on audio bandwidth and network latency.
I was using Airplay to play audio from my MacBook to a Raspberry Pi connected to a speaker. However, as detailed in this article, Airplay has issues in either Airplay 1 or Airplay 2 mode - one mode causes a large audio delay, and the other encodes audio to 256 kbps AAC. I wanted a solution that was low-latency, lossless, and optimized for LAN streaming.
First, install Rust if you haven't already.
Then install audio-stream from GitHub:
cargo install --git https://github.com/isaac-mcfadyen/audio-streamFinally, if you want to stream the audio output from a macOS source device, install Blackhole 2ch and set it as your output in the Audio MIDI Setup application.
On the receiving side, run audio-stream recv, passing in the device and listen address:
# Example: receiving and outputting via PulseAudio on Linux
# -d = audio device name
# -l = address to listen on (including port)
audio-stream recv -d pulse -l 0.0.0.0:8000On the sending side, run audio-stream send, passing in the device, address of the receiver, and (optionally) any audio parameters:
# Example: recording and sending audio from Blackhole on macOS
# -d = audio device name
# -a = receiver address (including port)
# -b = buffer size (in frames) - optional, default 2048
# -r = sample rate (in Hz) - optional, default 44100
audio-stream send -d "Blackhole 2ch" -a 192.168.0.10:8000 -r 44100 -b 1024Licensed as MIT. See LICENSE for details.