Help getting a Raspberry Pi CANBUS hat going

[NGTOne]

I'm trying to get a PiCAN2 Duo going on a RasPi 4B with Ubuntu 22.04+Kairos, but nothing I do seems to make it work - it never detects the two CAN ports the board exposes. I've built an image with the settings from the PiCAN2 documentation in both /boot/config.txt and /boot/firmware/config.txt, and neither seems to have any effect.

$ cat /boot/config.txt 
# https://www.raspberrypi.com/documentation/computers/config_txt.html
# https://emteria.com/kb/connect-uart-rpi
# https://www.raspberrypi.com/documentation/computers/config_txt.html
enable_uart=1
uart_2ndstage=1

# Disabling bluetooth might change the serial device:
# https://raspberrypi.stackexchange.com/a/69721
# On rpi4, if bluetooth is not disabled (like here), the device is /dev/ttyS0
#dtoverlay=disable-bt
dtparam=i2c_arm=on
# dtparam=i2c_arm_baudrate=400000
dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25
dtoverlay=mcp2515-can1,oscillator=16000000,interrupt=24
dtoverlay=spi-bcm2835-overlay

$ sudo /sbin/ip link set can0 up type can bitrate 500000
Cannot find device "can0"

I've verified it works on a clean Raspbian, so I know it's something in the Kairos/Ubuntu configuration.

[sutyum]

Wonder if your issue was eventually resolved. I am trying to assess Kairos for a medical device which uses UART

[NGTOne]

Nope, never got it going. Project timeline forced me to switch back to Raspbian and I've not had time to experiment with it since.