Skip to content

Latest commit

 

History

History
62 lines (37 loc) · 3.64 KB

README.md

File metadata and controls

62 lines (37 loc) · 3.64 KB

Solar Panel Characterization with Arduino

Solar panel characterization with Arduino, with data analyses in Python.

Get your Solar Panel Datalogger Kit: Solar Panel Datalogger Kit for Arduino
See full tutorial here: Solar Panel Characterization and Experiments with Arduino

JUMP TO:

- Wiring Diagram
- Arduino Codes
- Python Scripts
- Example Output Plots

The solar-char library can be downloaded using git:

git clone https://github.com/makerportal/solar-char

- Wiring Diagram for Solar Datalogging-

The wiring between the components and the Arduino BLE-Nano board is given below: Solar Char Wiring

Note: we have omitted any explanation of the wiring configuration in order to declutter the tutorial, however, most of the wiring explanations can be found either on our site or in other literature/forums online. We will discuss the solar panel, potentiometer (rheostat), and INA226 current/voltage configuration later in the experimental setup section. The rest are left for the user to explore.

- Arduino Codes -

We first need to characterize the panel’s output range to find the optimal operating voltage. We do this by turning the rheostat (potentiometer) from minimum to maximum in order to vary the load on the solar panel. First, the Arduino code that logs and prints voltage and current must be uploaded to the microcontroller. In our case, we’re using the BLE-Nano, which acts similar to the Arduino Nano and Uno boards (ATmega328P at the center).

The code used to log and print voltage and current is given at the following code under the arduino folder:

For the long-term experiment, we left the entire box outside for a day with the solar panel mounted atop the box. The panel was pointed slightly east at an angle less than 15° (due to the slight opening of the box), but mostly vertical to ensure the highest power output. The box was left outside from 8:00 a.m. June 15th, 2021 until roughly 9:00 a.m. June 16th, 2021 in northeastern San Francisco, CA. Data points were acquired roughly every 60 seconds, based on the longterm Arduino code called:

- Python Scripts -

Identification of the panel's nominal open-circuit voltage, short-circuit current, max power voltage and current, and max power output can be conducted via the Python rheostat analysis code:

After retrieving the kit after an entire day’s worth of datalogging, we can then use the Python 3 script for the diurnal analysis:

- Example Output Plots -

The rheostat analysis output plot can be seen below:

Solar Panel Char Output

In the plot below, we plot the raw time-series plot of the power output from the solar panel:

Solar Panel Diurnal Plot

In the bottom plot of the figure above, we can identify some important parameters such as the daily power output and peak temporal output. We can also use this bottom plot to approximate the power output of the region where the panel is placed. See the full tutorial at the link above for more in-depth review and analysis of the plots.