Setting for air condition (AC)? Pulse with auto off but not return to the original status in HomeKit #1581
Replies: 2 comments 1 reply
-
No. Not in switch mode. And maybe a little bit: If you configure this as garage door you can have and configure the pulses. But you will not have state. So while theoretically this could be added a feature it will not really make sense. If you are away from home and your device incorrectly reboots/or somebody uses another switch you have no way of knowing the current state? |
Beta Was this translation helpful? Give feedback.
-
Hello again. I'm sorry to answer again but do you think an update with this would be possible? Maybe something as easy as a check so that the auto-off after 1 second does not change the status to off? This would be valid for any device that turns on with a press of 1 second and you want to maintain the status in the home app. Thank you! |
Beta Was this translation helpful? Give feedback.
-
Hello. I have doubts when configuring shelly 1 to simulate a press of the ON/OFF button of the thermostat of my wall air conditioner.
I currently have a shelly 1 but I did not program it and I need to change it because it is dead.
I need to simulate a press (1 second) BUT I want that in homekit the new state does not go back with the auto-off after 1 second, because the air conditioner will be in that new status.
Is this possible? Thanks!
Beta Was this translation helpful? Give feedback.
All reactions