Replies: 2 comments 7 replies
-
|
Thanks So much. |
Beta Was this translation helpful? Give feedback.
-
|
seems like my ps4 controller while connected as 2nd player vibrates all the time like crazy. like even when I'm on home screen it just vibrates nonstop. But if connected as player 1, vibration stops and when I connect the joycon as 2nd, then ps4 controllers as 1st player again start to vibrate. |
Beta Was this translation helpful? Give feedback.
-
|
You create an empty file called However if this is occuring when you unplug joycons this might not be the same issue. Controllers that are incompatible with the command I speak about will be disconnected by themselves shortly after connecting. |
Beta Was this translation helpful? Give feedback.
-
|
Ohh i know now, my joystick doesn't disconnect but it won't stop vibrating when i unplug my joycons and pair with the console at player 1-2, and in-game the vibration doesn't work too. |
Beta Was this translation helpful? Give feedback.
-
|
Only thing you can do for now is disable the rumble in the sysmodule configuration. Nothing has changed in the rumble code since I released it, this is a super strange issue that seems to be related to the 13.1.0 update. I'm looking into it but I currently don't understand why it's happening. |
Beta Was this translation helpful? Give feedback.
-
|
Okay i try to disable it :), maybe is a problem with firmware 13.1.0 or atmos last update. Thanks for reply faster 💪🏽 |
Beta Was this translation helpful? Give feedback.
-
|
The rumble issues are now fixed in v0.6.2 |
Beta Was this translation helpful? Give feedback.
-
MissionControl 0.6.1
This is the tenth official release of Mission Control.
Just a small update to add support for the latest HOS (13.1.0) and Atmosphère (1.2.1) versions, and a couple of minor fixes. See below for the full changelog.
Valid analog stick deadzone parameters are now stored in virtual SPI flash file for each controller. This resolves an issue reported by several users where some controllers were experiencing analog stick drift even after calibration due to incorrect deadzone parameters being applied. Please delete the controller entries under
sdmc:/config/MissionControl/controllers/so that these files can be recreated with the correct parameters. Note that you will need to redo any user calibrations after deleting these entries.Support for manually disabling a vendor command (SetTsi) for incompatible controllers has been added. Allowing the console to send the command to such controllers causes them to be disconnected shortly after connecting. In most cases, sending of this command can be disabled in code after the incompatibility has been reported. Some incompatible third-party controllers, however, are indistinguishable from the originals that do support the command and must be flagged manually. To do so, a blank file
settsi_disable.flagcan be created under the directory for a specific controller undersdmc:/config/MissionControl/controllers/<controller address>. Note that this command is used for managing bandwidth between bluetooth devices and also the Wifi chip. It is therefore desirable to have the console send it where possible and should only be disabled where absolutely necessary.New users landing on this release page should first check out the readme on the main project page for the official project documentation. There you can find installation and usage instructions along with an FAQ section that will answer most of your questions.
Atmosphère >= 1.2.0 is required to run this release.
Important notice for users of Xbox One controllers
It has been confirmed that the new Xbox Insiders controller firmware update will convert your controller to use Bluetooth LE, which is not currently supported. Please do not update if you wish to continue using your controller with Mission Control
Changelog:
This discussion was created from the release MissionControl 0.6.1.
Beta Was this translation helpful? Give feedback.
All reactions