Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Best way/how to do the hardware wiring? #2

Open
fishbonegaminglabs opened this issue Jan 23, 2019 · 1 comment
Open

Best way/how to do the hardware wiring? #2

fishbonegaminglabs opened this issue Jan 23, 2019 · 1 comment

Comments

@fishbonegaminglabs
Copy link

First time I soldered the wires to reflash the radio, but I find this a bit complicated to do it over and over again.
I do have soldering skills, but those pads will eventually go bad, so what is the best way to connect it?

Making a clip on connector could work?

@nepeee
Copy link
Owner

nepeee commented Jan 25, 2019

It is a passible solution to port the Arduino flasher code(https://github.com/fishpepper/CC2510Lib) to the tinyhawk stm32f4xx. Than we can make a permanent mod(connecting some pads) and use the Betaflight Configurator to flash our flasher software for rx fw updates.

For now you can solder some wire wrap(thin) wires to the pads and use a 2.54mm (0.1inch) pin header.
https://en.wikipedia.org/wiki/Pin_header

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Labels
None yet
Projects
None yet
Development

No branches or pull requests

2 participants