You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a cable connect between 2 switches.
the access-switch sa01 is a stack with more switches (sa01.1,a sa01.2,....) . The first of this stack (as01.1) is marked as master and shows all interfaces of the stack.
as01.1 interface 1/50 is direct connected to core01
as01.2 interface 2/50 is connected via many patchpanels (FP/RP...) to core02
in topology view I see sa01.1 with a logical connection and a cable. But both goes to the same end interfaces.
as01.2 is displayed as single extra switch with logical connection
I configure a LAG and put both interfaces to this. But the view give the same picture.
Update: both cable types are displayed when I select "Show redundant Cable and Logical Connection"
the parts of another stack are also displayed as a single switch ( but with correct logical connection )
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hi,
here some cases, they I don't understand.
the access-switch sa01 is a stack with more switches (sa01.1,a sa01.2,....) . The first of this stack (as01.1) is marked as master and shows all interfaces of the stack.
as01.1 interface 1/50 is direct connected to core01
as01.2 interface 2/50 is connected via many patchpanels (FP/RP...) to core02
in topology view I see sa01.1 with a logical connection and a cable. But both goes to the same end interfaces.
as01.2 is displayed as single extra switch with logical connection
I configure a LAG and put both interfaces to this. But the view give the same picture.
Update: both cable types are displayed when I select "Show redundant Cable and Logical Connection"
Beta Was this translation helpful? Give feedback.
All reactions