M2 POE Gateway open telnet fail

[miniknife88]

follow telnet readme,the LED does not turn purple

[niceboygithub]

Format USB thumb with FAT32 in Windows.

[miniknife88]

FAT32 format is ready，but the LED does not turn purple

[niceboygithub]

Single partition format to FAT32.

The gateway must be power off before hold the button.

[wu-cl]

I have the same problem. Use fat32 single partition usb device，power off before hold the button.
After re-Plug-in, the yellow light goes out and starts flashing blue, no purple.

[wu-cl]

Use MBR NOT GUID !! It WORKS!

[Sircoco2]

the yellow light goes out and starts flashing blue, no purple.

[niceboygithub]

the yellow light goes out and starts flashing blue, no purple.

Please check the format of your USB Disk. (MBR, single partition with FAT32)

[lihuohuo9527]

There will still be a TELNET password
Devices in aqara getaway cannot be used after M2 2022 (POE) restarts

[lihuohuo9527]

1. There is still a telnet password, but aqara getaway is working properly

2. After restarting the m2 Poe, the devices in the aqara getaway cannot be used

[yebjx]

telnet m2-2022-poe ，The username is admin, and the password is left blank, and the password is incorrect

[vachenli]

my usb disk is mbr signle partition with FAT32,and the m2 2022 light is change to purple,but , i cant telenet after it restart

[Chengxuyuan0]

telnet m2-2022-poe，用户名为admin，密码留空，密码不正确
I tried to connect to the M2-2022-POE device using Telnet with the username 'admin' and left the password field blank, but the password was not accepted. I encountered the same issue.

[xiaozhubin]

telnet m2-2022-poe，用户名为admin，密码留空，密码不正确
I tried to connect to the M2-2022-POE device using Telnet with the username 'admin' and left the password field blank, but the password was not accepted. I encountered the same issue.

试试用户名 root

[yunjie-li]

After trying many times, the phenomenon still changes from yellow light to blue light. I checked the USB format and confirmed it is MBR FAT32. There is no problem with the file. There is no problem with the operation. The m2 firmware version is the latest 4.3.1_0010.0013. Is this firmware not supported?