Error during boot

[kepello]

When connecting power to the ESP32, with my laptop connected to the USB cable for terminal, I see the following errors. I located a previous post about the same error message https://github.com/orgs/thehighnibble/discussions/86.

The suggestion was to check the uSD Card. The card appears correct when connected to my laptop, with 3 folders (cromemco, imsai and www).

The individual replied that they suspected they needed to reprogram the ESP32, but there was no comment made regarding the outcome. I don't know how to reprogram the ESP32 if that is the problem. Help?

      rst:0x3 (SW_RESET),boot:0x3f (SPI_FAST_FLASH_BOOT)
      configsip: 188777542, SPIWP:0xee
      clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
      mode:DIO, clock div:1
      load:0x3fff0030,len:4940
      ho 0 tail 12 room 4
      load:0x40078000,len:15120
      load:0x40080400,len:3764
      entry 0x40080620
      E (57) flash_parts: partition 0 invalid magic number 0x10aa
      E (58) boot: Failed to verify partition table
      E (59) boot: load partition table error!
      ets Jun  8 2016 00:22:57

[MKoenen1]

It looks like your ESP32 is not communicating with the psram. Did you solder the 6 extra pins on the ESP32? Check your connections on the psram smd. Take a look at the previous discussion #157. It has a good boot log in the psram init.

[kepello]

I found and followed the steps to re-program the ESP32, and now it boots and I can access the webpage via Wifi.

If anyone else has this problem, that seems to be the required step.