Readme.md

Solar Power Management Unit

Standalone Battery Backed Solar Power Module

Status

**2020-02-04 First status! In design.**
- Electrical: basic block design mostly fleshed out
- Mechanical: vague ideas of module enclosure and connectivity have been had
- Firmware: please hold while your party is being reached

Requirements:

- Solar MPPT controller
- Downstream Load management
- Battery protection (Undervoltage lockout, temperature lockout)
- Enough sensors to sense and report State-of-Health(SoH), State-of-Charge(SoC)
- Microcontroller to manage reporting of battery SoC/SoH, Coulombs in/out, module temperature, lots of other stuff.
- Support LiFePO4 (LFP) 3~4S battery with adjustable charge current limits
- Power requirements: maximal setup case 100W panel, 400Wh battery, 40W output
- Watertight (NEMA4/4X, IP65+) enclosure with connectivity through bulkhead connector or cable glands
- 2 year minimum design lifetime (for now, comments invited)

Current part selection:

Part prices are USD/1pc on Digi-Key
- STM32F030CCT: IC MCU 32BIT 256KB FLASH 48LQFP: $2.89
  - microcontroller
- BQ24650RVAR: IC SYNC SW-MODE BAT CHRGR 16VQFN: $4.8
  - MPPT + battery charge management
- TPS22810DRVR: IC PWR SWITCH N-CHAN 1:1 6WSON: $0.6
  - Load switch with adjustable UVLO, 3A current limiting