You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Jun 8, 2020. It is now read-only.
When your ESP hasn't saved any wifi connections it will create a wifi. Connect to this wifi. Usually you get a message that you need to sign in to the network. Click on it and you will get to the wifi setup page. Now you can configure your wifi.
If you don't get the message to sign in to the network:
Connect to the wifi and open this URL: http://192.168.4.1/
Now you will get to the wifi setup page and you can configure your wifi.
2. Get IP-Adress
Connect your ESP to serial monitor and set baud rate to 9600. At every the ESP will print its IP-Adress.
3. Open ESP-RGB-Controller page
Go into the same network as the ESP and connect to http://[IP of ESP]/
Now you can controll your RGB-Strips with your ESP board.