-
-
Notifications
You must be signed in to change notification settings - Fork 90
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Idea: Component Drawing Order #158
Comments
I like this idea. I think it would be even stretched a little further. We could abandon the |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Hello,
I would like to throw this out there for comments.
There are times, especially for back footprints, where one might want to draw stuff below the PCB. See below for an example, where the pin headers are actually populated from the bottom.
Where it should be like this:
One idea is to make a different element below the PCB element (
boardContainer
), and have all of the back components be drawn there. That is how I re-created the image above manually:If there are components on the bottom that also draw stuff at the top, then perhaps also split the component into two (could be based off an attribute).
The text was updated successfully, but these errors were encountered: