Create vp-digi-config.md

vp-digi-config.md

@@ -0,0 +1,64 @@
+# vp-digi-config.md
+The vp-digi section of the project must be configured using its interface.
+
+## Important Notes
+* Run `save` after you set the config. Very important.
+
+## `print` Output from VP-Digi
+```
+Callsign: VA6XXX-0
+Destination: APNV01
+TXDelay (ms): 1000
+TXTail (ms): 30
+Quiet time (ms): 300
+UART1 baudrate: 9600
+UART2 baudrate: 9600
+DAC type: PWM
+Flat audio input: yes
+Beacon 0: On, Iv: 100, Dl: 1, WIDE1-1, >Hello from JASPER satellite
+Beacon 1: Off, Iv: 0, Dl: 0, no path, 
+Beacon 2: Off, Iv: 0, Dl: 0, no path, 
+Beacon 3: Off, Iv: 0, Dl: 0, no path, 
+Beacon 4: Off, Iv: 0, Dl: 0, no path, 
+Beacon 5: Off, Iv: 0, Dl: 0, no path, 
+Beacon 6: Off, Iv: 0, Dl: 0, no path, 
+Beacon 7: Off, Iv: 0, Dl: 0, no path, 
+Digipeater: On
+Alias WIDE: On, max: 2, rep: 3, untraced, unfiltered
+Alias : Off, max: 0, rep: 0, untraced, unfiltered
+Alias : Off, max: 0, rep: 0, untraced, unfiltered
+Alias : Off, max: 0, rep: 0, untraced, unfiltered
+Alias -0: Off, untraced, unfiltered
+Alias -0: Off, untraced, unfiltered
+Alias -0: Off, untraced, unfiltered
+Alias -0: Off, untraced, unfiltered
+Anti-duplicate buffer hold time (s): 30
+Callsign filter type: blacklist
+Callsign filter list: 0 entries
+Auto-reset every (h): disabled
+KISS monitor: Off
+Allow non-APRS frames: Off
+```
+
+* Note that the `beacon 0` text is overwritten with telemetry in the firmware.
+
+## Configuration Script
+Run this config script in RealTerm or similar to set the configuration above.
+
+```
+config
+call VA6XXX
+dest APNV01
+quiet 300
+txdelay 1000
+beacon 0 on
+beacon 0 iv 1
+beacon 0 dl 15
+beacon 0 path WIDE1-1
+beacon 0 data >HIJASPER
+pwm on
+flat on
+save
+monitor
+beacon 0
+```