A breadboard-friendly ESP12E/F breakout with all I/O pins available, flash/reset buttons onboard, and place to directly use it with FTDI modules like FT232RL FTDI Serial Adapter Module.
| Top View | Bottom View |
|---|---|
 |
 |
| No | Component | Quantity |
|---|---|---|
| 1. | ESP8266 - 12e/f | 1 |
| 2. | 10KΩ 0805 smd resistors | 5 |
| 3. | SMD-SWITCH-6.2MM | 2 |
| 4. | Pin Header 1x11 Male 2.54 mm | 2 |
- If you want to power up ESP8266-Breakout directly from a FTDI board, you need to solder the jumper that exists on the bottom side of the ESP8266-Breakout. IMPORTANT: Do not forget to change the jumper to 3.3V instead of 5V, on the FTDI module.
- If you want to use ESP8266-Breakout with a breadboard.
- Connect Vcc to 3.3V
- Connect Gn to Ground
- You do not need to connect EN pin (ESP8266-Breakout itself has the required connection)
- You do not need to add any extra pull-up or pull-down resistors on GPIO15, GPIO2 or GPIO0 for Boot Mode Selection
This project was developed using free version of EAGLE 9.5.2
Gerber files are available here