-
联想ThinkPad T580 【4k的UHD显示屏:3840x2160(京东方BOE NV156QUM-N44,非触摸)】
-
英特尔i7-8550U CPU
-
内存16GB RAM DDR4 2400-SODIMM
-
东芝Q200EX SSD+128G 东芝nvme联想跟机带
-
英特尔以太网I219-V4 有线网卡
-
Mac原装无线网卡bcm94360cs2(原装英特尔AC8265无法正常工作) -
Wi-Fi设备芯片组为(0x14E4, 0x117) 显示Airport Extreme,使用AirportBrcmFixup.kext修改信道国家代码 -
蓝牙设备芯片组20702B0,固件版本:v150 c9318 免驱动 -
无线网卡改为DW1820A拆机卡(原装DELL拆机卡无需屏蔽针脚)
-
瑞昱Realtek ALC3287(“ALC257”)通过AppleALC.kext与layout-id:11,支持耳机和自带喇叭之间插拔自动切换。
-
Intel UHD Graphics 620(禁用Nvidia MX150,macOS不支持Optimus)
-
ACPI热修补电源管理和双电池状态
-
SD卡读卡器走usb3.0通道,需要打开此USB端口即可使用
-
Thunderbolt 3【BIOS里需要设置“Thunderbolt BIOS Assist”:Disable,“Security level” :No Security(允许自动连接 Thunderbolt 设备)。这样即可使前端类型USB type-c端口在macOS中工作,可以热插拔, DP / HDMI通过USB type-C:视频工作正常,连接扩展坞正常,雷电3设备工作正常,热插拔正常】
-
机器自带独立的HDMI端口:可以输出4k@30HZ到显示器。连接时会显示音频设备HDMI,并正常使用。
-
键盘Synaptics触摸板(PS / 2)使用ApplePS2SmartTouchPad.kext,EMlyDinEsH的v4.7b5,支持多点触控手势。 -
键盘触摸板已使用acidanthera/VoodooPS2Controller替代,支持多点触控手势,比ApplePS2SmartTouchPad好用
-
键盘F1-F12快捷键已经全部启用,参照https://github.com/MSzturc/ThinkpadAssistant ,鸣谢MSzturc和开发者们
-
睡眠和唤醒正常,两种方式
-
1.hibernatemode 3 (这种睡眠方式可能会影响硬盘性能和寿命,这也是白果笔记本默认睡眠方式)
往 EFI/CLOVER/kexts/Other和OC引导的kexts下面扔一个 HibernationFixup.kext,可以实现 hibernatemode 3 休眠。 如果合盖后遇到偶发性的随机唤醒或者重启,禁用 proximitywake :sudo pmset -a proximitywake 0 -
2.hibernatemode 0 (这种睡眠方式只写入到内存,推荐使用)
sudo pmset -a hibernatemode 0
sudo pmset -a proximitywake 0
- WWAN(无模块)
- TrackPad Synaptics指纹识别器无法驱动
- BIOS里设置Thunderbolt BIOS Assist为Disable(Enable雷电由BIOS控制决定,Disabled雷电由操作系统控制决定),“Security level” :No Security(允许自动连接 Thunderbolt 设备和TYPEC)。
- BIOS里设置usb项Always on USB为enable,下面子项Charge in Battery Mode设置为enable(这样雷电口type-c就可以热插拔type-c外设)
- 关闭安全启动
- BIOS版本 1.20-1.31通用
- 指纹无法驱动。
解决10.15.x的type-c,HDMI无输出问题: 从10.15开始,S/L/E下无法通过config的KernelToPatch来打补丁了,所以需要自己手动打补丁,我把10.15.4的已打好的补丁放上了,自行替换S/L/E下同名驱动文件。
- 第一种方法: 每次更新大小系统版本后终端里执行一次sudo mount -uw / && killall Finder和sudo kextcache -i /,然后重启机器即可。如果方法一不灵就强制使用方法二暴力破解了。
- 第二种方法:
打开终端输入一下命令,即可对系统进行读写:
sudo mount -uw /
killall Finder
- 下载AppleGraphicsDevicePolicy.kext然后替换到/System/Library/Extensions/AppleGraphicsControl.kext/Contents/PlugIns/下 ,修复权限缓存重启即可:sudo touch /System/Library/Extensions/ && sudo kextcache -u /
- 注意:关于macOS下HDMI和typec输出请使用以下机型:
MacBookPro14,1 完美;
MacBookPro14,2 完美;
MacBookPro15,2 完美,可以同时HDMI,type-c;
MacBookPro14,3 type-c,HDMI,无输出-需要定制端口;
MacBookPro15,1 type-c,HDMI,无输出-需要定制端口;
MacBookPro15,3 type-c,HDMI,无输出-需要定制端口;
MacBookPro16,1 type-c,HDMI,无输出-需要定制端口;
MacBookPro16,4 type-c,HDMI,无输出-需要定制端口;
MacBookPro15,4 type-c输出正常,HDMI正常,不能同时;
MacBookPro16,2 type-c输出正常,HDMI正常,不能同时;
MacBookPro16,3 type-c输出正常,HDMI正常,不能同时;
其他机型比如MacBook Air8,1和8,2还有9,1没测试,有兴趣自己测试一下;
尽量避免使用:MacBookPro14,3;MacBookPro15,1;MacBookPro15,3;MacBookPro16,1;MacBookPro16,4这些机型。
MacOS on Lenovo ThinkPad T580 (this guide also applies to P52s i7-8550u, 8250u should be general in theory, not T480s)
This repository contains a sample configuration for 10.13 or later running macOS on a Lenovo ThinkPad T580
-
Lenovo ThinkPad T580 [4k UHD display: 3840x2160 (BOE NV156QUM-N44, non-touch)]
-
Intel i7-8550U CPU
-
Memory 16GB RAM DDR4 2400-SODIMM
-
Toshiba Q200EX SSD+128G Toshiba nvme Lenovo with strap
-
Intel Ethernet I219-V4 wired network card
-
Mac original wireless network card bcm94360cs2 (original Intel AC8265 cannot work normally) -
The Wi-Fi device chipset is (0x14E4, 0x117) Display Airport Extreme, use AirportBrcmFixup.kext to modify the channel country code -
Bluetooth device chipset 20702B0, firmware version: v150 c9318 driver-free -
The wireless network card is changed to DW1820A disassembly card (the original DELL disassembly card does not need to shield pins)
-
Realtek Realtek ALC3287 ("ALC257") supports AppleALC.kext and layout-id: 11 to support automatic switching between headphones and its own speakers.
-
Intel UHD Graphics 620 (Nvidia MX150 is disabled, macOS does not support Optimus)
-
ACPI hot patch power management and dual battery status
-
SD card reader uses USB3.0 channel, you need to open this USB port to use
-
Thunderbolt 3 [Thunderbolt BIOS Assist" in the BIOS needs to be set: Disable, "Security level": No Security (allows automatic connection of Thunderbolt devices). In this way, the front-end type USB type-c port can work in macOS and can be hot-swapped. DP/HDMI through USB type-C: the video works normally, the docking station works normally, the Thunderbolt 3 device works normally, and the hot plug works normally]
-
The machine comes with an independent HDMI port: it can output 4k@30HZ to the display. When connected, the audio device HDMI will be displayed and used normally.
-
Keyboard Synaptics touchpad (PS/2) uses ApplePS2SmartTouchPad.kext, v4.7b5 of EMlyDinEsH, supports multi-touch gestures. -
The keyboard touchpad has been replaced with acidanthera/VoodooPS2Controller, supports multi-touch gestures, and is easier to use than ApplePS2SmartTouchPad
-
All keyboard shortcuts F1-F12 have been enabled, please refer to https://github.com/MSzturc/ThinkpadAssistant, and thank MSzturc and developers
-
Sleep and wake up normally, two ways
-
- hibernatemode 3 (this sleep mode may affect hard disk performance and life)
Toss a HibernationFixup.kext under the kexts of EFI/CLOVER/kexts/Other and OC,hibernatemode 3 sleep can be achieved. If you encounter an occasional random wake-up or restart after closing the lid, disable proximitywake: sudo pmset -a proximitywake 0
- hibernatemode 3 (this sleep mode may affect hard disk performance and life)
-
- hibernatemode 0 (this sleep mode is only written to memory,Recommended Use)
sudo pmset -a hibernatemode 0
sudo pmset -a proximitywake 0
- hibernatemode 0 (this sleep mode is only written to memory,Recommended Use)
- WWAN (no module)
- TrackPad Synaptics fingerprint reader cannot be driven
- Set Thunderbolt BIOS Assist to Disable in the BIOS (Enable Thunderbolt is determined by BIOS control, Disabled Thunderbolt is determined by operating system control), "Security level": No Security (allows automatic connection of Thunderbolt devices and TYPEC).
- In the BIOS, set the USB item Always on USB to enable, and the following sub-item Charge in Battery Mode is set to enable (so that the lightning port type-c can be hot-swapped type-c peripherals)
- Turn off safe boot
- BIOS version 1.20-1.31 common
- Fingerprint cannot be driven.
Solve the 10.15.x type-c, HDMI no output problem: Starting from 10.15, it is not possible to patch through KernelToPatch in config under S/L/E, so I need to manually patch it. I put the patch that has been patched in 10.15.4 and replace it under S/L/E. Driver file with the same name.
- the first method: Run sudo mount -uw /&& killall Finder and sudo kextcache -i / in the terminal once after updating the size system version, and then restart the machine. If the first method fails, the second method is forced to brute force.
- The second method:
Open the terminal and enter the command to read and write the system:
sudo mount -uw /
killall Finder
- Download AppleGraphicsDevicePolicy.kext and replace it under /System/Library/Extensions/AppleGraphicsControl.kext/Contents/PlugIns/ , Just fix the permission cache and restart: sudo touch /System/Library/Extensions/ && sudo kextcache -u /
- Note: For HDMI and typec output under macOS, please use the following models:
MacBookPro14,1 perfect;
MacBookPro14,2 perfect;
MacBookPro15,2 perfect, can simultaneously HDMI, type-c;
MacBookPro14,3 type-c, HDMI, no output -Custom port required;
MacBookPro15,1 type-c, HDMI, no output -custom port required;
MacBookPro15,3 type-c, HDMI, no output -custom port required;
MacBookPro16,1 type-c, HDMI, no output - required Custom port;
MacBookPro16, 4 type-c, HDMI, no output - custom port is required;
MacBookPro15, 4 type-c output is normal, HDMI is normal, but not at the same time;
MacBookPro16, 2 type-c output is normal, HDMI is normal, not at the same time;
MacBookPro16 ,3 type-c output is normal, HDMI is normal, not at the same time;
other models such as MacBook Air8, 1 and 8, 2 and 9, 1 have not been tested, if you are interested in testing it yourself;
try to avoid using: MacBookPro14,3; MacBookPro15, 1; MacBookPro15,3; MacBookPro16,1; MacBookPro16,4 these models.