nrf24le1-orangepi

A simple command-line interface with Nordic nRF24LE1 using a Orange Pi and the spidev driver.

Pinout

Signal	Orange Pi	nRF24LE1 (QFN32)
CS	SPI0_CS	P1.1
MOSI	SPI0_MOSI	P0.7
MISO	SPI0_MISO	P1.0
CLK	SPI0_CLK	P0.5
PROG	PA13	PROG
RESET	PA14	RESET

Known issues

The spidev buffer size might be too small, fix with

chmod u+w /sys/module/spidev/parameters/bufsiz

echo 65536 > /sys/module/spidev/parameters/bufsiz

Features

• Program memory read/write
• NVM memory read/write
• InfoPage handling

Command Line Format

For further development, the tool should conform to the above protocol.

Miscellaneous

nrf24le1 show

Show the FSR register and make sure we can modify it, this demonstrates proper communication on the SPI bus to the nRF24LE1 module.

nrf24le1 reset

Reset the unit on the programmer, this resets the MCU to start the program afresh.

Reading data from nRF24LE1

nrf24le1 read infopage [filename]

nrf24le1 read firmware [filename]

nrf24le1 read nvm [filename]

All read operations dump data to stdout by default, in Intel Hex format. It's possible to provide an optional filename as an argument.

When a filename is specified and the extension matches .hex or .ihx the dump will be saved in Intel Hex format, otherwise the binary format will be used.

Writing data to nRF24LE1

nrf24le1 write firmware [filename]

nrf24le1 write infopage [filename]

nrf24le1 write nvm [filename]

All write operations expect data from stdin by default, in Intel Hex format. It's possible to provide an optional filename as an argument.

When a filename is specified and the extension matches .hex or .ihx the dump will be saved in Intel Hex format, otherwise the binary format will be used.

Additional Parameters:

(not yet implemented)

Parameter	Function
--offset N_BYTES	Skips N_BYTES bytes
--count N_BYTES	Read/Write only N_BYTES bytes

References

• Nordic nRF24LE1: http://www.nordicsemi.com/eng/Products/2.4GHz-RF/nRF24LE1