Complementing rear pullout of bus-boxx with cable chain plus Neutrik connector
Replacing the orginal 12V car plug by a neutrik jack. Connecting with cable chain to rear pull out to protect cables.
- Print all stl´s referenced in section printing instructions
- For 12V cables 2.5mm2 cables have been used. For the Neutrik plug cable terminators (Wire End Ferrule Pliers)have been used. All relevant parts have been protected with Heat Shrink Tubes. For the cables 1+ and 1- have been used respectively.
- For the Neutrik Jack the parts Nut for Neutrik Adapter and Screw for Neutrik Adapter have to be mounted to the Neutrik Adapter
- The Cable Chain has been mounted to the Adapter Multirail with two M3 screws (taken from the set Stainless Steel Screw Kit, protected by Screw Lock
- The other end of the Cable Chain has been mounted to the Rear pullout platform
- If necessary the 12V plug itself can be protected against sliding out by Screws for safety holder plus Safety holder
Nut for Neutrik Adapter: Printed with Ender3 Super Fine Quality 0.12mm, 90% Infill, No support
Screw for Neutrik Adapter: Printed with Ender3 Super Fine Quality 0.12mm, 90% Infill, No support
Neutrik Adapter: Printed with Ender3 Super Fine Quality 0.12mm, 90% Infill, Support only with touching plate
Adapter Multirail: Printed with Ender3 Super Fine Quality 0.12mm, 90% Infill, No support
Safety holder: Printed with Ender3 Super Fine Quality 0.12mm, 90% Infill, No support
Screws for safety holder: Printed with Ender3 Super Fine Quality 0.12mm, 90% Infill, No support
Rear pullout platform: Printed with Ender3 Standard Quality 0.2mm, 20% Infill, No support