HomeAssistant AjaxSecurity Bridge

DISCLAIMER: This component is under active development now. There are no any stable release yet, so please do not use it in your installation unless you are developer who would like to contribute into module

Bridge between ajax security modules and Home Assistant. The modules connects to the home assistant instance via UART Bridge which provides Jeweller(native ajax radio protocol) <> UART interface.

This integration doesn't use Ajax cloud services, doesn't require internet connection and doesn't expose any data outside of local network. However it requires special hardware module to interface Ajax wireless protocol, see Required Hardware section below.

Currently supported Ajax products are:

• Fire Protect

Required Hardware

• Ajax UART Bridge, to interface wireless Ajax devices
• USB-UART adaptor, to connect UART bridge to home assistant server. Please avoid super low-cost chineese adaptors as they might be extreamly unstables.

USB-UART devices known to work fine

• Chinees devices built on CP2102 chip

USB-UART devices known to work poorly or doesn't work

• TBD

Instalation

From releases section download the latest realease. Put ajax_security folder from archive into custom_components folder of your home assistant installation. In the root of home assisatnce configuration add the following:

ajax_security:
  name: bridge0
  port: /dev/ttyUSB0
  baudrate: 57600

Make sure to edit port to match the real device name.

TBD

Configuration

Name	Type	Default	Description
name	string	uart_bridge0	Name of the integration module. Must be set to unique value in case you need 2 or more simultaneously connected UART bridges.
port	string	required	Path to TTY devices. May vary depending on USB-UART adaptor and operation system. Check your /dev/tty*. Example: /dev/ttyUSB0
baudrate	positive int	57600	Baudrate of the the serial interface. Currently Ajax Bridge operates on 57600
timeout	positive int	3	Socket time out in seconds

Development

For development purposes it is highly recommended to bootstrap the new and clean home assistnant environment. You may use the content of the dev_hass_config folder to start. Just put it in some folder which will be you project root and create virtual environment with reqired dependancies:

virtualenv venv
source ./venv/bin/activate
pip install -r ./requirements.txt

Now you could run local home assistant instance like this: hass

Documentation which describes UART Bridge protocol is available here.

Credits

Dmitry Berezovsky

Disclaimer

This module is licensed under GPL v3. This means you are free to use it even in commercial projects.

The GPL license clearly explains that there is no warranty for this free software. Please see the included LICENSE file for details.