Home

Welcome to the Irrigo wiki!

In order to use the Irrigo project you must connect the hardware properly, here is the drawing of a possible implementation:

-Once uploaded the firmware and connected all the devices, turn on the system and search the WiFi AP named "Irrigo".

-Using a Web Browser connect to the default IP address of the device: 192.168.4.1.

-The index page is shown, go to the settings tab and click on WiFi menu, now insert SSID and password of your WiFi AP, so that the Irrigo can connect to it.

-Reboot the Irrigo to be sure that is connected to your WiFi AP, you can try to connect to the Irrigo by going to the page "http://irrigo", because Irrigo supports mDNS. In case that you don't find it, go in your WiFi AP web interface find the Irrigo IP address on the network.

-Once connected to Irrigo you can now configure MQTT to match the one configured on Home Assistant