The following is the configuration used on my Creality K1 3d Printer.
The original configuration can be found in the original-config
branch for comparison, see diff here.
If you decide to use this configuration, make sure to re-run the following:
- PID configuration for bed and extruder
- Input Shaper
- Bed Mesh
All of these parameters vary from printer to printer due to small manufacturing differences.
NOTE: I am in no way responsible for your printer.
You might also want to check the following:
- Rotation distance
My printer was over-extruding slightly, hence it has been adjusted.
- Set idle timeout to 5 minutes (was essentially disabled)
- Removed Stop motors from the END_PRINT macro.
This allows us to move the bed if needed without homing the printer again. - Enabled Stealthchop on X,Y and Z steppers.
This quiets down the printer quite a bit. - Set X, Y Max Velocity to 600mm/s (was 1000mm/s)
- Reduced X Y Max Acceleration to 15000mm/s^2 because of stealthchop (was 20000mm/s^2)
- Set Z Max Velocity to 7.5mm/s (was 20mm/s)
Making it less noisy. - Set Z acceleration to 150mm/s (was 300m/s)
- Adjusted rotation distance on extruder from to 6.8 (from 6.9)
- Enabled firmware retraction (0.2mm at 100mm/s)
- Set recovery velocity to 100mm/s (was 500mm/s)