Skip to content

An open source application for programming HCS EEPROM Code Hopping. Support keeloq key generation from manufacturer code for Simple, Normal and Secure learning algorithm.

License

Notifications You must be signed in to change notification settings

ioelectro/hcs-programmer-soft

Repository files navigation

HCS Programmer Software

An open source application for programming HCS300 & HCS301 EEPROM Code Hopping.
Support keeloq key generation from manufacturer code for Simple, Normal and Secure learning algorithm.

HCS301 Programmer Software

Download

Download latest release

Required .NET Framework 4.7.2 or Upper.

Description

This software requires an interface hardware that can write information to the HCS.The information is sent to the interface via the com port using a usb to serial converter.

Hardware

Any hardware that supports UART serial communication can be used as an interface and hardware. For example, ARDUINO PIC AVR STM8 are a good choice.

Protocol

UART,8 Data,1 StopBit,No Parity,BaudRate 9600

Transmit

  • Device identification (Optional)
  • Information to be programmed

Device identification

Immediately after opening the port, the software sends the character ! and if it does not receive a response, it does so up to three times.
response must send at below format:
! DEVICE-NAME-(STRING) \n

Information to be programmed

According to the information in the HCS datasheet, 12 WORD 16-bit should be set.
The sending packet contains 25 bytes that are sent as follows:
> WORD0 WORD1 WORD2 WORD3 WORD4 WORD5 WORD6 WORD7 WORD8 WORD9 WORD10 WORD11

Sending this package does not require a response. Instead, the programmer can display the result, error or any message that is described in the following section.

Receive

The received packages consist of three main sections, which are shown below:
TYPE-(Char) MESSAGE-(STRING) \n

Packet TYPE

  • Log <
  • Info i
  • Warning w
  • Error e

Example

Print data to log:
< HELLO \n

Show Warning message:
w Warning! \n

About

An open source application for programming HCS EEPROM Code Hopping. Support keeloq key generation from manufacturer code for Simple, Normal and Secure learning algorithm.

Topics

Resources

License

Stars

Watchers

Forks

Packages

No packages published

Languages