Skip to content

Examples of how to create a custom firmware for the remosty boards.

Notifications You must be signed in to change notification settings

jorgecis/Remotsy

Repository files navigation

Remotsy board


DESCRIPTION

Remotsy is a ESP8266 equipped with a infrared blaster and receiver. The board's stock firmware is programmed to communicate with Remosty cloud,but it's possible to flash the board with any firmware. Here are some examples:

Example 1 RGB LED

 The board has a RGB neo pixel LED, the led is connected to the pin 14. the example use the ticker function to
 blink the led.

Example 2 Infrared Receiver

  The board has a infrared receiver TSOP38238 that is connected to the pin 5,  Using the library IRremoteESP8266
  is possible to capture and decode an infrared code. This example is the same that exist in the library

Example 3 Infrared Emissor

  The board has 4 infrared led that are conntect to the pin 4,  Using the library IRremoteESP8266 is possible to
  transmite almost any infrared code. This example is the same that exist in the library

Buy the board

https://www.tindie.com/products/10469/

Flashing

To flash the board, you need connect the serial pins (TX,RX and GND) and also connect the pin 0 to ground and press the reset button. The easy way to do this is connect the pins with the yellow arrow.

Connect pin 0 to ground

Releases

No releases published

Packages

No packages published

Languages