Release Marlin v2.0.7.2-r4 for Saphhire Plus v2 (gen2)

this fork of firmware Marlin v.2.0.7.2 espescially prepared for 3D Printer TwoTrees Sapphire Plus v2 (gen2) with two independent Z-axis (for each Z-axis have a dedicated driver). Beware! It is not compatable with Sapphire Plus gen1 that used belt betwen two Z-axis motors and one driver for two z-axis motors.

• enabled S_CURVE_ACCELERATION
• Marlin color UI
• enabled bed PID-control (PIDTEMPBED)
• adjusted PID parameters for hotend and bed
• UI black edition
  

Release Marlin v2.0.7.2-r2 for Saphhire Plus v2 (gen2)

this fork of firmware Marlin v.2.0.7.2 espescially prepared for 3D Printer TwoTrees Sapphire Plus v2 (gen2) with two independent Z-axis (for each Z-axis have a dedicated driver). Beware! It is not compatable with Sapphire Plus gen1 that used belt betwen two Z-axis motors and one driver for two z-axis motors.

• enabled S_CURVE_ACCELERATION
• Marlin color UI
• enabled bed PID-control (PIDTEMPBED)
• adjusted PID parameters for hotend and bed

Release Marlin v2.0.7.2-r1 for Saphhire Plus v2 (gen2)

Marlin v.2.0.7.2 espescially for Sapphire Plus v2 (gen2)

this fork of firmware Marlin v.2.0.7.2 espescially prepared for 3D Printer TwoTrees Sapphire Plus v2 (gen2) with two independent Z-axis (for each Z-axis have a dedicated driver). Beware! It is not compatable with Sapphire Plus gen1 that used belt betwen two Z-axis motors and one driver for two z-axis motors.

• enabled Linear Advance (LIN_ADVANCE) and disabled S_CURVE_ACCELERATION
• MKS UI (like a default UI on Sapphire Plus)
• enabled bed PID-control (PIDTEMPBED)
• adjusted PID parameters for hotend and bed (you are able to re-calibrate with the m303 command and save in EEPROM with the m500 command)
• correct position of leveling corners in LCD menu