AutoLISP-Files

My own autolisp routines, with some commands and routines for luthiery specific drawing tasks

startup.lsp

My CorelCAD startup file, to automatically load my customizations

divisions.lsp

It allow to construct new lines from the division between two defined points

Line From Mid Point

linefrommidpoint

Ask to define two points; a mid point is calculated, and a line start to be drawn from there. The new line finish when defining the third and last point.

Line From Third Point

linefromthirdpoint

Ask to define two points; the point at one third their distances is calculated, and a line start to be drawn from there. The new line finish when defining the third and last point.

Line From Golden Section

linefromgoldensection

Ask to define two points; then, a point at the golden section from them is calculated, and a line start to be drawn from there. The new line finish when defining the third and last point.

vesicapiscis.lsp

It construct a Vesica Piscis from two defined points

Vesica by Start End

vesicastartend

Ask to define both opposite extreme points, then draw the Vesica.

Vesica by Center End

vesicacenterend

Ask to define the center and one of the opposite extreme points, then draw the Vesica.