2.0.0 Firmware for Parrot 3D

New Features

• Now support 0.9° and 1.8° stepper motor
• Now support NeoPixel LED upto 30 LED (Use with BigTreeTech DCDC V1.0 power module)
• Enable Linear Advance with S-Curve Acceleration
• Enable Junction Deviation Factor
• Driver monitoring for error conditions like over temperature and short to ground.
• Support filament run out
• Add Chris Warkocki's Custom Command
• Stronger stepper motor movement
• Automatic turn on hot-end cooling fan when temp more than 50C and automatic turn off when temp less than 50C
• Many more...

Fixed Issue

• A fixed thermal runaway when use in cold winter.
• A fixed stepper motor noise when run fast. (Noise come from TMC StealthChop mode.)
• Many more...

1.0.1 Firmware for Parrot 3D

This release fixes bugs in Parrot 3D 1.0.0, in particular a auto bed levelling that affect the consistency of bed levelling.

Bug Fixed

• Fixed AUTO_BED_LEVELING_BILINEAR (ABL)
• Turn off Experimental Subdivision of the grid by Catmull-Rom method.

1.0.0 Firmware for Parrot 3D

This is first release for Parrot 3D

This is firmware use for Parrot 3D with Bondtech Extruder

• BTT SKR 1.4 Turbo
• TMC2209 Drivers
• Stepper Motor: NEMA 17, 1.8° Step Angle, 200 Steps Per Revolution, 1 Amp
• Bondtech MK3s Mosquito
• Slice Engineering Mosquito