GUI

PiEEG-Club is a place, where researchers, coders, and any neuroscience enthusiast can share some scripts for PiEEG devices. Make neuroscience available for all Please be free add your GUI in this repository
Manual
Manual for quick start

https://pieeg.com/
Contact: pieeg@pieeg.com

Signal test

Alpha in EEG signal

Artefacts (chewing and blinking) in EEG signal

EMG signal

EKG signal

Pinout between Pi and PiEEG

Connect the shield to Raspberry Pi which is supplied via a 5V battery (power supply) and connect electrodes. Full galvanic isolation from mains is required.
This also applies to the monitor. Use only a monitor that is powered by the Raspberry Pi, as in the picture below, left. Electrodes are positioned according to the International 10-20 system, right

Warnings

Warning

PiEEG is not medical device. You are fully responsible for your personal decision to purchase this device and, ultimately, for its safe use. PiEEG is not a medical device and has not been certified by any government regulatory agency for use with the human body. Use it at your own risk.

Caution

The device must operate only from a battery - 5 V. Complete isolation from the mains power is required.! The device MUST not be connected to any kind of mains power, via USB or otherwise.
Power supply - only battery 5V, please read the liability

Citation

I. Rakhmatuiln, et all. (2021). Raspberry Pi Shield - for measure EEG (PIEEG). 2021 5th International Conference on Electrical, Electronics, Communication, Computer Technologies and Optimization Techniques (ICEECCOT), 410-413. DOI: 10.1109/ICEECCOT52851.2021.9707969 link

Rakhmatulin, I., Volkl, S. (2020). PIEEG: Turn a Raspberry Pi into a Brain-Computer Interface to measure biosignals. arXiv:2201.02228, https://arxiv.org/abs/2201.02228

Contacts

http://pieeg.com/
pieeg@pieeg.com