Simple Arduino code which takes Flipsky remote UART packets to: trigger STOP light / WS2812, control headlights or other relays.
| PIN | DESCRIPTION | INVERTED |
|---|---|---|
| 0 | RX input (TX from Flipsky remote receiver) | - |
| 3 | STOP/IDLE LIGHT - HIGH active | n |
| 4 | STOP/IDLE LIGHT - LOW active | y |
| 6 | WS2812 / WS2812b signal | - |
| 9 | EXTRA OUTPUT - LOW active (smash quickly 5 times reverse to toggle) | y |
| 10 | HEADLIGHT OUTPUT - LOW active (smash quickly 3 times reverse to toggle) | y |
| 11 | EXTRA OUTPUT - HIGH active (same as above, PIN 9) | n |
| 12 | HEADLIGHT OUTPUT - HIGH active (same as above, PIN 10) | n |
Connect Arduino pin 0 (RXD) to TXD of Flipsky remote receiver.
- Going forward will lit WS2812 dark red.
- Idle or breaking will light WS2812 bright red + STOP pin will be switched HIGH
- Quickly smash full reverse 3 times to toggle HEADLIGHT pin ON/OFF
- Quickly smash full reverse 4 times to toggle stealth mode ON/OFF (no lights - default states on pins)
- Quickly smash full reverse 5 times to toggle EXTRA pin ON/OFF
Adafruit_NeoPixel to drive WS2812b leds. https://github.com/adafruit/Adafruit_NeoPixel
Flispky 2.4Ghz Remote VX1 https://flipsky.net/products/flipsky-remote-vx1?gclid=CjwKCAjwu_mSBhAYEiwA5BBmf9LBBx9PpFKv5CgjhqQj1TavKo4SD233scOLS4ZKl-M7fe24MMejLRoCQYQQAvD_BwE