Barobord MX with added underglow support

In addition to the existing MX version with per key LEDs, added underglow with a jumper to allow using:

• Just per key LEDs
• Per key LEDs and Underglow
• Underglow only (doing this requires that you solder the jumper on the top side of the pcb, near the MCU)

In this release, I also flipped the MX switch footprints so that the per key leds are on the top side of the switch instead of the bottom. For backlit keycaps with legends on the top of the key, they light up much nicer with this version

Bring your own MCU (byo-mcu)

First release of the bring your own MCU version (MX only). Note that this one has not been tested, but it's based on the Atmega32u4 version, so the board is much simpler, and just had some basic re-routing required. I'm quite sure it will work fine, but wanted to add that disclaimer.

Barobord Choc v1

This has been available and tested for quite some time. I have been personally using this one for a few months with no issues. I hadn't created a release, so publishing now.

First MX release

Original MX release, tried and tested for months with no issues. I recommend the MX 1.1 release over this one, as it has underglow support, and the switch footprints were flipped upside down so that the per key leds are at the top instead of the bottom of the switch