Skip to content

Check

Jump to bottom
srg74 edited this page May 30, 2021 · 8 revisions

For testing your board remove a jumper before connecting to power.

Jumper No jumper

Check if no short circuit on power terminals.

Test1

⚠️ IMPORTANT: If you have a 5V power supply set it to 5V and if you have a 12V or 24V power supply put it to 12V ⚠️ Place power selector jumper back in position regarding of your power source (5V or 12/24V). Connect power supply and check if there is a voltage on pins 5V and GND. To do this place two jumper wires (or other type of wire) into a header.

Test2

If all steps went fine you can place your board on shield.
⚠️ IMPORTANT: Pay attention on board orientation and pins placement. Here is reference images ⚠️

Placement1 Placement2 Placement3

After you place your board on shield, you can powered up and connect LEDs of your choice.

Ready board

GUIDE:

  1. Choose options
  2. Order PCB
  3. Order parts
  4. Assembly
  5. Check
  6. Pinout
  7. Firmware
  8. Enclosure
  9. Usermods

USEFUL:

Clone this wiki locally