Environment

Setting up the environment

Step 1 - If your board requires a proprietary toolchain, install that.

• Spartan 6 based boards require Xilinx ISE. Xilinx ISE is a propitary toolchain which must be installed manually.

  This is most boards, including

  • MimasV2,
  • Opsis,
  • Atlys,
  • Pipistrello,
  • minispartan6/minispartan6+

• "Series 7" based boards require Xilinx Vivado. Xilinx Vivado is a propitary toolchain which must be installed manually.

  These boards include;

  • NeTV2,
  • Nexys_Video,
  • Arty

• TODO: Cyclone V based boards require Altera Quatras Altera Quatras is a propitary toolchain which must be installed manually.

  These boards include;

  • De Nano???

• TODO: ICE40 based boards require Yosys, Anancr-PNR. [XXXX] is an open source toolchain which can be installed automatically.

  These boards include;

  • IceStick?
  • ???

Step 2 - Install required system packages

• download-env-root.sh does this.

Bunch of packages are needed;

• Libraries for talking to USB - libftdi, libusb, fxload

• udev rules.

• Kernel modules for some boards. Mostly not needed....

Step 3 - Setup a self contained environment.

• download-env.sh does this.

The steps are;

• Get conda. Conda is a self contained Python install, kind of like virtualenv but includes the ability to install precompiled binary packages.

• Install precompiled C compiler toolchain from TimVideos Conda repo. This includes; binutils, gcc and gdb.

  • The C compiler toolchain is needed for compiling the BIOS and firmware.

• Install precompiled JTAG tool from from TimVideos Conda repo. The tool we use is openocd.

• Install dependent Python packages (from pip/conda/elsewhere). Things like pyserial and stuff.

• Install tools for simulation and testing. Things like verilator.

• Install tools for helping manage FPGA boards. Things like HDMI2USB-mode-switch, MimasV2Config.py, flterm.

• Initialising submodules and install litex packages from third_party/.

This is completely contained in the build/conda directory. Removing that directory will totally remove the installed environment.

Step 4 - Enter self contained environment & set environment variables.

• If you installed Xilinx to anywhere other than /opt/Xilinx/, run export XILINX_DIR=<path>. This must be set before entering the environment, as it is not updated from within it.

• source scripts/enter-env.sh - enter-env checks that your environment is setup correctly and contains all the dependencies you need.

• export PLATFORM=<platform> - Default is Opsis

• export TARGET=<targetname> - Default is dependent on the platform.

After entering environment

Build gateware for the FPGA

• make gateware

Load or Flash gateware onto the FPGA

• make load - Load firmware temporarily onto your board. Should come back from a power cycle in the previous state.
• make flash - Permanently write firmware onto your board. After a power cycle the board will come up with your flashed configuration.