Numato Opsis

Jump to bottom Edit New page

Tim Ansell edited this page Sep 1, 2018 · 4 revisions

Configuring the Opsis

To use the Opsis, you need to set the jumpers correctly, connect cables correctly and then put the board into JTAG mode.

FIXME: Put something here about the Opsis.

Jumpers Configuration

The jumpers as set on the Opsis when it ships work.

FIXME: Put picture showing correct jumper configuration.

Cables

The programming computer must be connected to the USB-B port.

JTAG mode

By default the Opsis will boot into HDMI2USB mode. To load gateware onto the board it must be switched into JTAG mode.

FIXME: Add instructions for switching the Opsis into JTAG mode.

HDMI2USB-mode-switch then run:
```
hdmi2usb-mode-switch --mode=jtag
```
Connect to console and use fx2 switch command.