a Python utility for programming various Microchip MCU devices using Microchip CMSIS-DAP based debuggers

Experiments with Microchip Curiosity Nano boards

Create an Agricultural IoT Sensor Node with AVR DD and RN2xx3 LoRa Module

This example uses the MCC Melody Library to show how to configure the device with a software delay and blink the LED on the AVR128DB48 Curiosity Nano development kit.

This repository contains the project that comes preloaded on the PIC16F13145 Curiosity Nano board. It contains a simple state machine demo of the Configurable Logic Block (CLB).

GitHub Example for the 8bit MDFU Client Library using PIC18F56Q24 with a CNANO board.

pykitinfo provides information about connected Microchip development kits and tools

This MPLAB® X MCC example shows implementation of TCP/IP Lite Applications using Microchip ENC28J60 Ethernet Driver on a PIC® Device

This MCC based MPLAB X IDE example shows how to interface an electret microphone with a microcontroller (MCU) using the Analog Signal Conditioning (OPAMP). In addition to the microphone, only one resistor and one capacitor are required.

This code example demonstrates how to communicate as host and client using SPI protocol in interrupt and polling mode on PIC18F56Q71 with MPLAB MCC Melody.

GitHub Example for the 8bit MDFU Client Library using AVR128DA48 with a CNANO board.

GitHub Example for the 8bit MDFU Client Library using PIC16F18446 with a CNANO board.

The AVR128DA48 features one 12-bit differential ADC. This example demonstrates the RMS voltage measurement of AC supply using differential ADC.

This MCC based MPLAB X example shows how to calibrate the gain and offset of the OPAMP when configured as a Programmable Gain Amplifier (PGA). The internal DAC and ADC are used to perform the calibration procedure. No external components are required.

This example uses the MCC Melody Library to show how to use the Analog to Digital Converter (ADC) to read a signal then send it out with the Universal Synchronous and Asynchronous Receiver-Transmitter (USART). Works with MPLABX or MPLAB XPRESS IDE.

This code example will use the ADC module to do an analog read and display on the USART port using a Terminal to see the values.

The repository contains the Manchester Encoder, an MPLAB® X project, using Core Independent Peripherals (CIPs) by following the interaction between CLB, TMR0 and UART peripherals.

This project showcases a full duplex communication between two AVR16EB32 Curiosity Nano boards through FSK data modulation and demodulation techniques implemented using timer peripherals.

This MPLAB® X Melody project supports the Application Note AN3607 Phase Sequence Detection of Three-Phase AC Supply and developed on AVR128DA48 Curiosity Nano Evaluation kit. This application uses ZCD and ADC peripherals of AVR DA family microcontroller.

This MPLAB® X MCC example shows implementation of TCP/IP Lite Applications using Microchip ENC28J60 Ethernet Driver on an AVR Device