You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Turn your FPV Combat board, sensor and gun to a nice ground target and a reliable test station!
You'll need [FPV Combat kit](https://fpv-combat.com/) and some other parts, full list below.
Bottom plate has holes for easy mount on any standard camera tripod.
Custom firmware for FPVCombat HW25 in form of `.hex` file can be downloaded from [Releases](https://github.com/ysoldak/fpvc-target/releases).
Custom firmware for FPVCombat boards in form of `.hex` file can be downloaded from [Releases](https://github.com/ysoldak/fpvc-target/releases).
<table>
<tr><td>
Expand DownExpand Up
@@ -44,6 +44,7 @@ Wiring of the sensor, gun, HC-12 and addressible 10 RGB strip is straightforward
- Solder XT60 male connector to "+" and "-" of the board to power from any standard battery. Best if with extra mounting brackets to screw to the base plate.
- Solder mode switch to TRIG connector, shorting Signal and Ground enables "TARGET" mode.
- Connect 5V of I2C to any of RC PWM 5V (TRIG, IN or OUT)
- On HW26, sensor shall be connected to `Sensor 1` pins, other sensor pins will not work.
